Selvage Edge, Shedding and Color Transfer: What's Normal in New Minky

|Tiffany Hoffman
A length of smooth ivory minky laid flat on a wooden cutting table, its long finished selvage edge running along the bottom of the frame

The selvage edge is the finished strip, about an inch wide, that runs down each long side of a length of fabric. On minky it can look slightly different from the rest of the fabric, or a little imperfect. That is normal. A little loose fiber when you first cut new minky is normal too.

Most guides to the selvage are written for woven quilting cotton. Minky is a knit with a cut pile, and it behaves differently. This guide is from EZ Fabric, a minky specialist in the Los Angeles Fashion District since 1995. It covers what each of these looks like on minky, why it happens, what to do about it, and how to tell a normal characteristic from a genuine defect when your fabric arrives.

about 1 in
Selvage on each long edge
2 to 3
Washes until shedding settles
30 days
From delivery to report a defect

What is the selvage edge on minky fabric?

The selvage is the finished edge along each long side of the fabric. It is about an inch wide. It is there for handling, and it can look slightly different from the rest of the fabric or a little imperfect. On minky it is part of the fabric, not a flaw, and it is accounted for in the price.

Which edge is the selvage?

The selvage runs the length of the fabric, parallel to the long edges of your cut. EZ Fabric cuts minky continuously from the roll. A cut of any length therefore has a selvage down both long sides and a raw cut edge at each end.

Do you need to cut off the selvage?

No. You can leave it on or cut it off, and both work.

  • Leave it on. In a blanket, or any project where the edge is sewn into a seam, the selvage can sit inside the seam, where it is never seen.
  • Cut it off. If you prefer a clean, even edge to measure from, trim it before you cut your pieces, using the cutting technique in the next section.

For a blanket, the fabric width is the blanket width. Minky arrives 58/60 inches wide, a range the width comes in, and a seam allowance takes only 5/8 inch off each edge. For working out lengths, see our guide “How Much Is a Yard of Fabric?”

The short version. The selvage, light shedding in the first washes, and minor flaws at the very ends of a roll are all normal in new minky. A run, a hole, a misprint, or the wrong color or size is a defect, and EZ Fabric will make it right.

Why does new minky shed, and when does it stop?

Minky sheds at first because it is a cut-pile fabric. Its fibers are shaved to an even length, and every cut you make severs more of them. A cut edge sheds for a bit while you work with it, and a new piece sheds a little in its first washes. It usually settles after 2 to 3 washes.

A shorter pile has less fiber to lose. If you would rather have less loose fiber to deal with, a smooth, low pile such as Solid Silky Minky Smooth, at 3mm, has less to shed than a high pile such as Whispy Snuggle, at 15 to 20mm.

How do you stop new minky from shedding?

You cannot stop a new cut pile from shedding entirely, but you can get most of it over with before you sew.

  1. Shake each piece out after you cut it.
  2. Vacuum up the loose fiber before you sew. If you work with minky often, a small tabletop or handheld vacuum is worth the modest investment.
  3. Give the fabric a quick wash before you sew, if you want the first-wash shedding behind you before the fabric reaches your machine.

How you cut matters most. Turn the fabric over so the knit back faces up. Find the point on your scissors blade that glides without opening and closing, and push through in one continuous motion. The blade parts the pile rather than chopping it, and far less loose fiber comes away at the edge. Our guide “How to Sew Minky Fabric” covers cutting and machine settings in full.

Water temperature and drying are covered in our guide “How to Wash a Minky Blanket”. One point from it belongs here: shedding that starts long after a blanket is broken in is more likely to be heat damage from a hot dryer than a fault in the fabric.

Should you wash new minky on its own?

Wash new minky in cold water, and on its own for the first few washes. In cold water, deep shades hold their color. Hot water is what can make a deep shade release color, and heat also damages the pile. A new piece sheds loose fiber, and that fiber transfers onto other laundry. Once the shedding settles, after 2 to 3 washes, it can go in with the rest of your laundry. Keep it away from anything with hooks or zippers that could catch the pile.

Choosing whites and light shades

Whites need one more step before you order. Whites and shades of white, including ivory and cream, read differently on screen. That applies to the white and cream colors of a plush texture such as Bella Snuggle® - Neutrals as much as to smooth minky. A 4 by 4 inch sample swatch costs $4.50 and shows you the exact color before you buy yardage.


Folded navy minky and folded white minky in two woven baskets on a wooden floor in a bright laundry room

Whites, ivories and creams read differently on screen.

Three more things that look wrong but are not

Two pieces that look like different shades

Minky has a nap: the pile leans one way. Stroke it and it feels smooth in one direction and rougher in the other. Two pieces cut with the nap running opposite ways read as two different shades, even when they came off the same roll. That is light catching the pile at different angles, not a fault in the fabric. Cut every piece with the nap running the same way.

A flattened patch from folding

A pile that is crushed from being folded or stored under weight is not damaged. A no-heat tumble in the dryer can often lift it.

Minor flaws at the very ends of a roll

Minor flaws at the very beginning and end of a roll are normal, and they are accounted for in wholesale pricing. This matters most if you buy full rolls.

Is it normal or a defect? What to check when your fabric arrives

Inspect your fabric as soon as it arrives, before you cut or wash it. This table sorts what you might find.

What you see Normal or a defect? What to do
A strip about an inch wide down each long edge that looks slightly different Normal: the selvage Leave it inside a seam, or cut it off
Loose fibers on your table after cutting Normal Shake out, vacuum, and cut with the knit back facing up
Some shedding in the first washes Normal: settles after 2 to 3 washes Wash the piece on its own at first
Two pieces that look like different shades Normal: the nap Cut every piece with the nap running the same way
A flattened patch from folding Normal Try a no-heat tumble in the dryer
Minor flaws at the very start or end of a roll Normal Expected on full rolls
A run or a hole Defect Report it
A misprint Defect Report it
The wrong color or size Defect Report it



Hands unfolding a length of fawn plush minky on a table by a window to inspect it on arrival

Check new fabric in daylight as soon as it arrives, before you cut or wash it.

How do you report a genuine defect?

If something is genuinely wrong, EZ Fabric will make it right.

  1. Email [email protected] with a photo of the issue.
  2. Include the exact yardage affected, which lets the team credit you accurately.
  3. Add your full name, order number and company name, if you have one.

Report it within 30 days of delivery. After 30 days you can still open a claim, but you cover the return shipping. An approved claim is resolved with a replacement or store credit. The full process is in our help article “Damaged, Defective, or Wrong Item”.

Wholesale orders follow the same steps, with one difference. EZ Fabric does not accept wholesale damage claims below 5% of the order quantity, because minor selvage and roll-end variation is expected and already reflected in wholesale pricing. Wholesale credits go to your account. Details are in “Wholesale Returns, Damages, and Restocks”.

For the short support version of this page, see our help article on what's normal in new fabric. When you are ready to choose fabric, browse our minky fabric or the solid Snuggle textures.

Frequently asked questions

Do I need to cut off the selvage on minky fabric?

No. The selvage on minky does not have to be trimmed. It can sit inside a seam, where it is never seen, or you can cut it off for a clean edge to measure from. Both work. It is about an inch wide on each long edge and is a normal part of the fabric.

Which edge of minky fabric is the selvage?

The selvage runs along both long sides of a length of minky, parallel to its length. EZ Fabric cuts minky continuously from the roll, which puts the selvage on the long edges and leaves a raw cut edge at each end.

How long does new minky shed?

New minky usually stops shedding after 2 to 3 washes. A freshly cut edge sheds for a bit while you work with it. Shaking the pieces out, vacuuming the loose fiber after cutting, or a quick wash before you sew gets most of it over with early.

Should I wash new minky on its own?

Yes, for the first few washes, and always in cold water. New minky sheds loose fiber, and that fiber transfers onto other laundry. The shedding usually settles after 2 to 3 washes. Deep shades hold their color in cold water. Hot water is what can make them release it. After the first few washes, minky can go in with the rest of your laundry, away from anything with hooks or zippers that could catch the pile.

Is a flaw at the end of a roll a defect?

No. Minor flaws at the very beginning and end of a roll are normal and are accounted for in wholesale pricing. A run, a hole, a misprint, or the wrong color or size is a defect. Report it to EZ Fabric within 30 days of delivery with a photo and the exact yardage affected.